Installing the upgrade options
Note: Most internal upgrade options are ordered and arrive pre-installed. This
Installing a hard drive
See Figure 2 on page 8 to identify the hard drive access door.
Figure 8. Removing the hard drive cover
1. Place the IBM 4836 face down on a sturdy surface.
2. Unfasten the two captured screws to remove the HDD door ( A ) . See
3. Locate the slot and brackets and insert the hard drive ( B ).
Note: Note the optional wireless card ( C ). If ordered, this card is installed at the
Installing additional memory
To install additional memory refer to Figure 2 on page 8. This figure identifies the
memory access door.
1. Place the 4836 face down on a sturdy surface.
section is provided for technical personnel only.
Figure 8.
factory. For removal and replacement procedures, see"Removing the
wireless card" on page 31.
Chapter 2. Installing the IBM Anyplace Kiosk
13