Removing The Wireless Card - IBM 4836 Planning, Installation And Service Manual

Removing the wireless card

Follow these steps to remove the wireless card:
Note: You do not have to remove the back cover to remove the wireless card.
1. Place the 4836 face down on a sturdy surface.
Figure 18. Removing the wireless card
2. Remove the two captured screws and lift to remove the hard drive door (see
3. Rotate the antenna connectors upward to disconnect, noting the AUX and MAIN
4. Locate and press outward on the card brackets to unlock.
5. Lift out the wireless card.
6. To replace, angle the card downward, then rotate the opposite end down until it
7. Reconnect the antenna, ensuring that the AUX and MAIN antenna correctly
8. Replace the hard drive door and secure the screws.
B
C
A
A in Figure 18). This door allows you access to the optional wireless card.
labels ( B and C ) on the cables.
Note: Take care not to crimp these cables.
latches into place.
match the connectors.
Chapter 4. Removing and replacing FRUs
31