Table of Contents
Advertisement
DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Parameter
Metric Offset
Passive Interface
Click the Apply button to accept the changes made.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
RIPng Database
This window is used to display the RIPng routing database.
To view the following window, click L3 Features > RIPng > RIPng Database, as shown below:
The fields that can be configured are described below:
Parameter
IPv6 Address/Prefix Length
Click the Find button to locate a specific entry based on the information entered.
OSPF
OSPFv2
OSPFv2 Process Settings
This window is used to display and configure the OSPFv2 process settings.
Description
Enter the value to be added to the metric of an IPv6 RIP route received on the
configured interface here. The range is from 1 to 16. The metric refers to the
hop count. By default, when receiving an IPv6 RIP route, a metric value of 1 is
added to the route before it is inserted into the routing table. Use this option to
influence the metric of routes received on different interfaces and influence the
preference of the route.
Select the Default option to use the default metric offset value, which is 0.
Select to enable or disable the passive interface feature here. If this option is
disabled, the router will not send RIPng packets out through the interface.
However, RIPng packets from other routers received on the interface will
continue to be processed.
Figure 6-224 RIPng Database Window
Description
Enter the IPv6 address that will be used for these results here.
206
Advertisement
Table of Contents
