Table of Contents
Advertisement
DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Click the Delete button to delete an entry based on the information entered.
Click the Edit button to configure the specific entry.
After clicking the Edit button, the following page will appear.
The fields that can be configured in Configure RIP interface are described below:
Parameter
Send Version
Receive Version
Send v2-broadcast
Authentication Mode
Authentication Text
Password
Click the Apply button to accept the changes made.
Click the Back button to return to the previous window.
RIP Database
This window is used to display the Routing Information Protocol (RIP) routing database. Summary address entries will
appear in the database only if relevant child routes exist and are being summarized. When the last child route for a
summary address becomes invalid, the summary address is also removed from the routing table.
To view the following window, click L3 Features > RIP > RIP Database, as shown below:
The fields that can be configured are described below:
Parameter
Network Address
Figure 6-30 RIP interface (Edit) Window
Description
Select a RIP version to send on the interface. Options to choose from are
v1(RIPv1) and v2(RIPv2).
Select a RIP version or both to receive on the interface. Options to choose from
are v1(RIPv1), v2(RIPv2) and v1/v2(Both).
Select to enable or disable the sending of version 2 RIP update packets as
broadcast packets instead of multicast packets.
Select to disable or enable text authentication mode.
Enter the authentication text password. It will be used if authentication mode is
enabled. The password can be up to 16 characters long.
Figure 6-191 RIP Database Window
Description
Enter the subnet prefix and the prefix length of the network(s) to be displayed
here.
203
Advertisement
Table of Contents
