Disc Operations - Panasonic SC-HC30 Operating Instructions Manual

Disc operations

g Inserting a disc
 Press [^] to turn the unit on.
 Press [;, CD] to open the sliding door.
 With the label of the disc facing towards you, tilt the disc into the
disc tray under the sliding door.
 Place the disc onto the spindle in the center and then push the
disc down until it clicks into place.
Click!
 Press [;, CD] to close the sliding door.
Keep fingers away from the sliding door when it is closing to avoid
possible minor injuries.
g Removing a disc
 Press [;, CD] to open the sliding door.
 Hold the center and the top right of the disc and pull the top right
of the disc to unlock it from the spindle.
 Tilt the disc so as not to touch the sliding door and remove the
disc.
• Damage may occur if the sliding door is forced closed.
• Be careful of CD hitting the sliding door while being removed.
Basic play
 Press [^] to turn the unit on.
 Insert the disc to be played (➡ left).
 Press [CD q/h] to start play.
Stop
Press [g].
Pause Press [CD q/h]. Press again to resume play.
Skip track
Press [u/t] or [y/i].
Search the current
Press and hold [u/t] or [y/i].
track (CD)
Skip album (MP3)
Press [e,r].
CD: Press the numeric buttons to select the
Direct access play
(Play starts with the track.
track you select.)
MP3:  Press [e,r] to select the album.
 Press [y/i] once and then the
numeric buttons to select the track.
Program play
Enables you to program up to 24 tracks.
 Press [CD q/h] and then [g].
 Press [PROGRAM].
CD:  Press the numeric buttons to select the track.
To program more tracks, continue by pressing the numeric
buttons.
 Press [OK] or [CD q/h] to start play.
MP3:  Press [e,r] to select the album.
 Press [y/i] once and then the numeric buttons to select
the track.
 Press [OK].
To program more tracks, repeat step  to .
 Press [CD q/h] to start play.
Cancel program Press [PROGRAM] in the stop mode to clear
mode "PGM" indicator from the display.
Press [PROGRAM] in the stop mode and then
Replay the program
[CD q/h].
Check program
Press [u/t] or [y/i] when "PGM" is
contents
displayed in the stop mode. To check while
programming, press [PROGRAM] twice after
"PGM" appears and then press [u/t] or
[y/i].
Delete last Press [DEL] in the stop mode.
programmed track
Clear all Press [g] in the stop mode.
programmed tracks
"CLR ALL" is displayed. Within 5 seconds,
press the button again to clear all tracks.
• The program memory is cleared when you open the sliding door.
Display function
Press [DISPLAY, –DIMMER] repeatedly during play or pause to view
the current track's information.
• Maximum number of displayable characters: approximately 30
• This unit supports ver. 1.0 and 1.1 ID3 tags. Text data that is not
supported will not be displayed.
9
9