Memory Reset (Initialization); Maintenance; Specifications - Panasonic SC-HC30 Operating Instructions Manual

Memory reset (Initialization)

When the following situations occur, reset the memory:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
To reset memory
 Disconnect the AC power supply cord. (Wait for at least 3 minutes
before proceeding to step 2.)

Maintenance

g
Pull out the power plug from the outlet for maintenance
beforehand and then wipe it using a soft and dried cloth.
• When dirt is heavy, wring the cloth moistened in water tightly to wipe
the dirt, and then wipe it with a dried cloth.
• Do not use solvents such as benzine, thinner, alcohol and detergent,
which may deform the coating of the outer case.
• When using a chemical cloth, follow the precautions.
Specifications
g AMPLIFIER SECTION
RMS Output Power
Front Ch (both ch driven) 20 W per channel (6 Ω), 1 kHz, 10 % THD
Total RMS power
FTC Output Power Stereo mode
Front Ch (both ch driven)
15 W per channel (6 Ω), 20 Hz to 20 kHz, 10 % THD
Total FTC Stereo mode power
Phone jack
Terminal
Output level (CD, 1 kHz, -20 dB)
Aux (Rear)
Terminal
g TUNER SECTION
Preset Memory
Frequency Modulation (FM)
Frequency range
Antenna terminals
Amplitude Modulation (AM)
Frequency range
g DISC SECTION
Disc played [8 cm (3") or 12 cm (5")]
(1) CD-Audio (CD-DA)
(2) CD-R/RW (CD-DA, MP3)
(3) MP3*
* MPEG-1 Layer 3, MPEG-2 Layer 3
14
14
Stereo, 3.5 mm (1/8") jack
max. 0.2 mW + 0.2 mW, 32 Ω
Stereo, 3.5 mm (1/8") jack
FM 30 stations
AM 15 stations
87.9 MHz to 107.9 MHz (200 kHz step)
87.5 MHz to 108.0 MHz (100 kHz step)
75 Ω (unbalanced)
520 kHz to 1710 kHz (10 kHz step)
 While pressing and holding down [8, POWER] on the main unit,
reconnect the AC power supply cord.
"--------" appears on the display.
 Release [8, POWER].
All the settings are returned to the factory preset. You will need to
reset the memory items.
g
Care on the CD lens
• Clean the lens regularly to prevent malfunctions. Use a blower to
remove dust and a cotton swab if it is extremely dirty.
• Do not use the lens cleaner of the CD type.
Pick up
Wavelength
Laser power
Audio Output (Disc)
40 W
Number of channels
g SPEAKER SECTION
Type
30 W
Speaker unit(s)
Full range
Passive Radiator
Impedance
g GENERAL
Power supply
Power consumption
Dimensions (W x H x D)
Mass (Weight)
Operating temperature range
Operating humidity range
Power consumption in standby mode:
• Specifications are subject to change without notice.
• Total harmonic distortion is measured by the digital spectrum
analyzer.
FL, FR, 2 channel
1 way, 1 speaker system (Passive Radiator)
/ ") Cone type x 1 / channel
6.5 cm (2 1
2
8 cm (3") x 2 / channel
AC 120 V, 60 Hz
500 mm x 201 mm x 102 mm
(19 11 / " x 7 29 /
16 32
(D = 69 mm (2 3 / ") minimum)
4
Approx. 2.8 kg (6.2 lb.)
0 °C to +40 °C
(+32 °F to +104 °F)
35 % to 80 % RH (no condensation)
0.05 W (approx.)
795 nm
CLASS 1
6 Ω
29 W
" x 4 1 / ")
32
14