Off Timer; Remote Control; Clock Settings - Panasonic DMR-EZ28K Operating Instructions Manual

Setup Menus
To change the password
After selecting "Parental Rating" (➔ 47, step 3)
Enter a 4-digit password with the
numbered buttons, then
e , r to select "Change Password",
then
Enter the new password with the
numbered buttons, then
– A screen appears confirming that you have
set a password. Press [OK].
Tips
To clear the password
(➔ 70, To reset the ratings level settings)
Notes
• Recording may fail when a wrong password was entered for
scheduled recording settings.
• "V-chip" technology enables restricted shows to be locked
according to TV ratings.
• The V-chip system that is used in this set is capable of blocking "NR"
programs (non rated, not applicable and none) as per FCC Rules Section
15.120(e)(2). If the option of blocking "NR" programs is chosen "unexpected
and possibly confusing results may occur, and you may not receive
emergency bulletins or any of the following types of programming:"
– Emergency Bulletins (Such as EAS messages, weather warnings and others)
– Locally originated programming
• News • Political
– Public Service Announcements
• Religious • Sports • Weather

Off Timer

Select how long the unit remains on when it is not being used.
Perform step 1 of "Accessing the Setup Menus" (➔ 46).
e , r to select "Setup", then q
e , r to select "Off Timer", then
e , r to select "2 Hours", "6 Hours"
or "Off", then

Remote Control

Use this function to synchronize the codes for the
remote control and the main unit.
Perform step 1 of "Accessing the Setup Menus" (➔ 46).
e , r to select "Setup", then q
e , r to select "Remote Control",
then
48
RQT9046
e , r to select "Set Code 1", "Set Code
2", or "Set Code 3" then
While pressing and holding
press and hold the numbered button
, , or
the code set in step 4 for about 5
seconds to set.
to complete.

Clock Settings

Perform step 1 of "Accessing the Setup Menus" (➔ 46)
e , r to select "Setup", then q
e , r to select "Clock Settings", then
Set Clock Automatically
After selecting "Clock Settings" (➔ above, step 3).
e , r to select "Set Clock
Automatically", then
to start auto setting.
The following dialog appears when setting is complete.
Set Clock Automatically
Clock Setting completed successfully.
4/4/2006 12:15 AM
DST........ .......
Time Zone ....
to complete.
Notes
• This may take some time, up to a few hours in some cases.
• If the following message appears
Set Clock Automatically
Setup
Setting completed as follows.
Finish the setup with this clock time?
Note: Selecting "No" will start channel scanning
Channel again and renew the clock time.
Yes
Setup
Disc
12/14/2005 5:28 AM
DST..................
Video
Time Zone....... EST
Audio
Display
ENTER
If the time is correct, [ w ] to select "Yes", then [OK].
– If you select "No", auto setting starts again, then the above
screen reappears. Repeat this step until the correct time appears.
• If the clock is not correct, set the clock with "Adjust Time Zone"
(➔ 49) or "Set Clock Manually"(➔ 49).
to set.
,
corresponding to
On
EST
No
Off