Table of Contents
Advertisement
Presentation Modes
By default you must press the external trigger to read a bar code. Use the
following commands to adjust how the engine behaves.
Presentation Mode: The engine automatically detects bar codes, then
scans and transmits the data. The laser turns off afterward.
Presentation Mode with CodeGate®: The engine automatically detects
bar codes and decodes them. However, the data is not transmitted until
you press the external trigger. The laser remains on briefly after the trans-
mission.
Presentation Mode
Presentation Mode with
CodeGate
Manual Activation Mode
In Manual Activation Mode, you must press the external trigger to scan a
bar code. The engine scans until a bar code is read, or until the external
trigger is released. Default = Manual Activation On.
Manual Activation Mode Off
* Manual Activation Mode On
End Manual Activation After Good Read
After a bar code is successfully read, the laser can be programmed either to
remain on and scanning, or to turn off. When End Manual Activation After
Good Read is enabled, the laser turns off and stops scanning after a good
read. If you scan Do Not End Manual Activation After Good Read,
3 - 6
Advertisement
Table of Contents
