Honeywell N431X User Manual page 118

ISBT 128 Predefined Concatenation Sequences On/
Off
The following selections allow you to enable or require the Predefined
ISBT 128 Concatenation Sequences.
If you scan Off, the predefined concatenation sequences are disabled.
If you scan the Allow Predefined Sequence code, then the engine will
output only the data combination specified in the predefined
concatenation sequence you selected.
If you scan the Require Predefined Sequence code, the data
combination specified in the predefined concatenation sequence you
selected is required to transmit the data. No data is output unless the
sequence is read.
Default = Off.
Require Predefined Sequence
ISBT 128 User-Defined Concatenation Sequences
Note: You must enable Code 128 and ISBT 128 to use this feature.
The following bar codes are used to create a custom ISBT 128
Concatena-tion Sequence. Select the identifiers you want to transmit in
the 1st and 2nd positions, both left and right. Refer to the ISBT 128
Standard Techni-cal Specification for the list of data identifiers.
Use the ASCII Conversion Chart,
acters needed for the identifier. Locate the hex value for each character
and scan that 2 digit/character value from the
the back cover of this manual.
Example: You want to create a concatenation sequence that has the
Donation Identification Number (001) as the left identifier, and
Product Code (003) as the right identifier.
The ISBT Index of Data Structures shows that for the Donation Identifica-
tion Number, the first character is "=" and the second character can be
from A-N; P-Z; 1-9. For this example, use "G." The Product Code first
character is "=" and the second character is "<."
6-26
* Off
Allow Predefined Sequence
beginning on page A-3, to find the char-
Programming Chart inside