Number Of Beeps - Good Read; Number Of Beeps - Error; Led Indicators - Honeywell N431X User Manual

Number of Beeps – Good Read
The number of beeps of a good read can be programmed from 1 - 9. The
same number of beeps will be applied to the beeper and LED in response
to a good read. For example, if you program this option to have five
beeps, there will be five beeps and five LED flashes in response to a
good read. The beeps and LED flashes are in sync with one another.
Note: The LEDs can also be programmed separately. See
Settings
To change the number of beeps, scan the following bar code and then
scan a digit (1-9) bar code and the
Chart inside the back cover of this manual. Default = 1.
Number of Beeps – Error
The number of beeps and LED flashes emitted by the engine for a bad
read or error can be programmed from 1 - 9. For example, if you program
this option to have five error beeps, there will be five error beeps and five
LED flashes in response to an error.
Note: The LEDs can also be programmed separately. See
Settings
To change the number of error beeps, scan the following bar code and
then scan a digit (1-9) bar code and the
Programming Chart

LED Indicators

The external LED can be programmed to be On or Off. Use the following bar
codes to program the external LED indicators. Default = LED On with Good
Scan.
Note: The external LED refers to the signal Good Read LED and is not a
physical LED on the engine.
3 - 4
on page 3-5.
Number of Good Read Beeps/LED Flashes
on page 3-5.
inside the back cover of this manual. Default = 1.
Number of Error Beeps/LED Flashes
Save bar code on the
Save bar code on the
LED
Programming
LED