Table of Contents
Advertisement
[CAC FILE]
[CAC FILE] cannot be selected right after the power is turned on, because boot of the camera is in progress.
This is not an error. Perform operation after a while.
Item
[CARD FILE SELECT]
[READ]
[DELETE]
[MAINTENANCE]
[CAC ADJUST]
[CAC ADJUST] cannot be selected right after the power is turned on, because boot of the camera is in progress.
This is not an error. Perform operation after a while.
Item
[CAC CONTROL]
[CAC FILE DELETE]
[CAC FILE NUMBER]
[LENS FILE ADJUST]
Item
[LENS FILE ADJUST]
[LENS FILE SW]
[LENS FILE MODE]
[FILE NO.]
[FILE NAME]
[EXECUTE]
[FLARE R]
[FLARE G]
[FLARE B]
[GAIN R]
[GAIN B]
[W H SAW R]
[W H SAW G]
[W H SAW B]
Chapter 4 Menu Operations — Menu list
Selects a file.
[1]...[100]
f Factory setting: [1]
Loads CAC files.
[YES], [NO]
Deletes the CAC file in the SD memory card.
[NO], [YES]
Selects whether to perform maintenance of CAC files stored in the camera's internal memory.
[OFF], [ON]
f Factory setting: [ON]
Selects a file to delete.
[YES], [NO]
Selects a file.
[1]...[32]
f Factory setting: [1]
Switches the enable/disable of the lens file.
[OFF], [ON]
f Factory setting: [OFF]
Selects the operation mode.
[LOAD], [STORE], [CANCEL]
f Factory setting: [LOAD]
Selects a file.
When [LENS FILE MODE] is [LOAD]:
[1]...[32]
When [LENS FILE MODE] is [STORE]:
[1]...[32]
f Factory setting: [1]
Enters a file name. (15 characters or less)
f Factory setting: [LENS FILE 1]
Selects whether to execute.
[NO], [YES]
Adjusts Rch flare of the data selected in [FILE NO.].
[−100]...[+100]
f Factory setting: [0]
Adjusts Gch flare of the data selected in [FILE NO.].
[−100]...[+100]
f Factory setting: [0]
Adjusts Bch flare of the data selected in [FILE NO.].
[−100]...[+100]
f Factory setting: [0]
Adjusts Rch gain of the data selected in [FILE NO.].
[−100]...[+100]
f Factory setting: [0]
Adjusts Bch gain of the data selected in [FILE NO.].
[−100]...[+100]
f Factory setting: [0]
Adjusts Rch white shading for the data selected in [FILE NO.] horizontally using a saw-toothed waveform.
[−100]...[+100]
f Factory setting: [0]
Adjusts Gch white shading for the data selected in [FILE NO.] horizontally using a saw-toothed waveform.
[−100]...[+100]
f Factory setting: [0]
Adjusts Bch white shading for the data selected in [FILE NO.] horizontally using a saw-toothed waveform.
[−100]...[+100]
f Factory setting: [0]
– 69 –
Description of settings
Description of settings
Description of settings
Advertisement
Table of Contents
