Table of Contents
Advertisement
5-3 Extended Menu
Item number Item name
713
VIDEO SETUP
REFERENCE LEVEL
(When operating in 525
mode)
Sub-Item
0
MASTER LEVEL
3
BETACAM PB
LEVEL (DNW-
A30/A30P only)
4
OUTPUT LEVEL
714
VIDEO ADJUST RANGE
(Items 715 to 721: Settings for controlling the video processing system according to the menu settings.)
Item number Item name
715
VIDEO GAIN CONTROL
716
CHROMA GAIN
CONTROL
717
CHROMA PHASE
CONTROL
718
SETUP LEVEL
719
SYSTEM PHASE SYNC
720
SYSTEM PHASE SC
721
Y/C DELAY (DNW-A30/
A30P only)
Note
When you make settings for items 715 to 721, set the
PROCESS CONTROL switch on the subsidiary
5-14
Chapter 5 Menu System
Menu items in the 700s, relating to video control (Continued)
Settings
Set the video setup amounts to be removed from a Betacam playback signal, and
to be added to a composite output signal. There are independent settings for, a
Betacam signal and a composite output signal (referred to below as an output
signal).
Note
The setup amounts specified in this menu item have no connection with the
SETUP (DNW-A30/30)/BLACK LEVEL (DNW-A30P/30P) knob on the subsidiary
control panel.
When the Betacam playback signal and output signal settings are "MSTER"
(master), the setup amount specified for this sub-item is removed from the
Betacam playback signal, and is added to the output signal.
0.0% ... 7.5% ... 10.0%: Setting in this range, in 0.5% increments.
MSTER : Set the Betacam playback signal to the master setting.
0.0% ... 7.5% ... 10.0%: Set the setup amount to be removed from the Betacam
playback signal in this range, in 0.5% increments.
MSTER : Set the output signal to the master setting.
0.0% ... 7.5% ... 10.0%: Set the setup amount to be added to the output signal in
this range, in 0.5% increments.
Select the variable range of the VIDEO and CHROMA controls when the
PROCESS CONTROL switch on the subsidiary control panel is set to LOCAL.
–3~+3 : –3 dB to +3 dB
WIDE: –∞ to +3 dB
Settings
Adjust the video output level.
Default value: 800H
Adjust the chroma output level.
Default value: 800H
Adjust the chroma phase.
Default value: 80H
Adjust the setup level (black level).
Default value: 110H
Adjust the SYNC control on the subsidiary control panel.
Default value: 80H
Adjust the SC control on the subsidiary control panel.
Default value: 0H
For playback from an analog Betacam cassette, adjust the Y/C delay.
Default value: 800H
control panel to MENU. When set to MENU, all
controls on the subsidiary control panel are disabled.
Advertisement
Table of Contents
