Table of Contents
Advertisement
!™ KEY INHIBIT switch
When this switch is in the ON position, the KEY
INHIBIT indicator in the lower control panel lights,
and the buttons in the upper control panel and lower
control panel specified by the setting of extended menu
item 118 are disabled.
!£ CAPSTAN LOCK switch
For playback and editing from tape, this switch selects
the capstan lock mode.
For DNW-A30/30
2FD: The capstan servo locks every two fields.
• There may be a color framing difference between
the tape playback output and the reference signal
selected by the OUT REF switch.
• For assemble editing, there may be a color
framing discontinuity at edit points.
During playback of a tape recorded with a
composite signal as source, there may be a
horizontal shift (H shift) of the image. (When
extended menu item 712 is set to ON.)
4FD: The capstan servo locks every four fields.
• There is no color framing difference between the
tape playback output and the reference signal
selected by the OUT REF switch.
• For assemble editing, color framing continuity at
edit points is assured.
During playback of a tape recorded with a
composite signal as source, no horizontal shift (H
shift) of the image occurs.
Select this position for editing and playback of
composite signals when video phase continuity at
edit points is required, or for A/B roll editing.
8FD (625/50): This position is not normally used in
a 525/60 system.
If you select this position in a 625/50 system, the
tape playback output is subject to virtual color
framing, frame-locked to the reference signal
selected by the OUT REF switch. (This unit is not
subject to color frame locking to the reference
signal.)
For DNW-A30P/30P
2FD/4FD: The capstan servo locks every two fields
(2FD)/four fields (4FD).
• There may be a color framing difference between
the tape playback output and the reference signal
selected by the OUT REF switch.
• For assemble editing, there may be a color
framing discontinuity at edit points.
During playback of a tape recorded with a
composite signal as source, there may be a
horizontal shift (H shift) of the image. (When
extended menu item 712 is set to ON.)
8FD: The capstan servo locks every eight fields.
• There is no color framing difference between the
tape playback output and the reference signal
selected by the OUT REF switch.
• For assemble editing, color framing continuity at
edit points is assured.
During playback of a tape recorded with a
composite signal as source, no horizontal shift (H
shift) of the image occurs.
Select this position for editing and playback of
composite signals when video phase continuity at
edit points is required, or for A/B roll editing.
Chapter 2 Location and Function of Parts
2-11
Advertisement
Table of Contents
