Table of Contents
Advertisement
Resetting the menu settings to their
factory default values (menu item B20)
Time data display
SET button
1
Set menu item B20 RESET SETUP to ON.
"PUSH SET BTN" appears in the time data
display, and "Push SET button" appears on the
monitor screen.
2
Press the SET button.
The current active menu settings (see page 5-7) are
reset to their factory default settings.
3
Press the SET button again.
The settings are saved and the menu display
disappears from the time data display.
Switching between 525/625 line systems
(menu item 013)
Using the following procedure, you can set basic menu
item 013, 525/625 SYSTEM SELECT, to "ON", and
then switch between 525 (NTSC) and 625 (PAL).
Note
Before carrying out this operation, consult the person
responsible for the installation. Switching the system
resets all menu items to their factory default settings.
(The following procedure shows by way of example
how to switch from a 525 (NTSC) system to a 625
(PAL) system.)
1
Select menu item 013.
The time data display and the monitor screen
connected to the COMPOSITE VIDEO OUTPUT
3 (SUPER) connector show the following displays.
Time data display
Monitor screen
ITEM-013
525/625 SYSTEM
SELECT
2
Holding down the JOG button, turn the search dial
to change the setting from "OFF" to "ON".
The displays change as follows.
Time data display
Monitor screen
ITEM-013
525/625 SYSTEM
SELECT
Push SET button!!
OFF
ON
(Continued)
5-5
Chapter 5 Menu System
Advertisement
Table of Contents
