Button Auto Write (Uw) - Omron V600 Operation Manual

Command Format
Response Format

3-2-9 BUTTON AUTO WRITE (UW)

One Processing Area
Command Format
Write
Header
ASCII/Hexadecimal code
setting
A: ASCII code, JIS 8 code
H: Hexadecimal code
Processing area
number setting
Response Format
40
U R 0 0
Read
Header
After the Hand-held Reader Writer has received the BUTTON AUTO WRITE
command, data will be written from the Data Carrier after the activate switch is
pressed and the Hand-held Reader Writer is held close to the Data Carrier. The
Hand-held Reader Writer will give a response once communications with the
Data Carrier are complete.
U W A/H 1 X
Start address No.
setting
U W
Write
Header
X X X X
Read data
area (1)
End code
00: Normal completion
(Refer to 3-3 End Code List for details.)
X X X X X
∗
0 0
End code
00: Normal completion
(Refer to 3-3 End Code List for details.)
Section
X X X X
Read data
area (2)
∗
X X
Sets the data to be written. The
number of bytes that can be written at
a time is as follows:
– ASCII: 256 characters (256 bytes)
– Hex.: 256 characters (128 bytes)
(Refer to page 30, WRITE Command
for details.)
3-2
∗