Auto Read (Ar) - Omron V600 Operation Manual

Command Format

3-2-4 AUTO READ (AR)

One Processing Area
Command Format
Read
Header
ASCII/Hexadecimal code
setting
A: ASCII code, JIS 8 code
H: Hexadecimal code
Processing area
number setting
Response Format
Two Processing Areas
Command Format
A R
Read
Header
ASCII/Hexadecimal code
setting
A: ASCII code, JIS 8 code
H: Hexadecimal code
Processing area
number setting
Response Format
Reads data when the Data Carrier has approached. The Hand-held Reader
Writer responds when the communication between the Hand-held Reader Writ-
er and Data Carrier has ended.
A R A/H 1
A R
Read
Header
Area (1) setting
A/H 2 X X X
Start address No. setting
A R 0 0
Read
Header
X X X X X
Start address No.
setting
0 0 X X X
End code
00: Normal completion
(Refer 3-3 End Code List for details.)
X X X A/H X
X X X X
Read data
area (1)
End code
00: Normal completion
(Refer 3-3 End Code List for details.)
Section
∗
X
Specify the number of bytes to be read
in hexadecimal code. The number of
bytes that can be read at a time is as
follows:
– ASCII: 256 bytes (256 characters)
– Hex.: 128 bytes (256 characters)
(Refer to page 29, READ Command for
details.)
∗
X
Read data
Area (2) setting
X X X X X
Specify the number of bytes to be read
in hexadecimal code. The number of
bytes that can be read at a time is as
follows:
– ASCII: 256 bytes (256 characters)
– Hex.: 128 bytes (256 characters)
(Refer to page 29, READ Command for
details.)
X X X X
Read data
area (2)
3-2
∗
∗
35