Advertisement
2
Installation
Before installing the IntelliChlor CIC60 system, please read all SAFEY PRECAUTIONS below.
Kit Contents
- One Primary Power Center
- One Secondary Power Center
- One Primary CIC60P cell
- One Secondary CIC60S cell
- Installation Guide (this manual)
Required Tools
- Medium phillips or flathead screwdriver (and four screws)
- Electric drill and 1/4" masonry drill bit. (To mount Power Center Bank)
SAFETY PRECAUTIONS - PLEASE READ BEFORE PROCEEDING
IMPORTANT SAFETY PRECAUTIONS. PLEASE READ THE FOLLOWING:
Read all the safety precautions in this manual before attempting any electrical wiring. Be
sure to read and follow all safety Instructions on page ii. Wiring should only be performed
by a qualified professional. When using electrical products, basic precautions should
always be followed, including the following:
RISK OF ELECTRIC SHOCK, WHICH CAN RESULT IN SERIOUS INJURY OR DEATH. Before
attempting installation of service, ensure that all power to the circuit supplying power to the
system is disconnected/switched off at the circuit breaker. The Power Center must be
interconnected with pool pump motor power source. This insures the IntelliChlor chlorinator and
pool pump will switch on and off together.
• Grounding (earth bonding) is required. The unit should be installed by a qualified service person
and grounded.
CAUTION - Install the IntelliChlor cell a minimum of two (2) feet from the heater outlet.
• Allow ample access to the IntelliChlor control panel buttons and the IntelliChlor Power Center.
• Pipe couplings: Schedule 80, maximum pressure 150 psi at 70° F.
• Operate unit with a minimum flow rate of 25 gpm per cell. For high flow applications, use a
bypass loop.
IntelliChlor Electronic Chlorine Generator COMSYS-4 Installation Guide
Advertisement
