Table of Contents
Advertisement
1. Post and Cure heater temperature setting
If the printed media becomes deformed, lower the post heater temperature at intervals
of 5 °C and the cure heater at intervals of 10 °C until the media deformation stops
occurring.
If blocking occurs on printed images, change the ink limit setting on RIP software.
[Adjusting ink limit]
Using ColorGATE RIP, right click on the job
under the "Color" tab
graph down to the required level.
Using ONYX RIP, Right click on the job
"Color Correction" tab
"Edit Type" tab
check the CMYK on the "Edit Channels"
required level.
Select "Settings"
select the "Color Correction" tab
Open the "Job in Job Editor"
select the "Primary Color Curves"
32
select "Settings"
select "Advanced"
select the "Line" on the
drag the graph down to the
drag the
select the
Advertisement
Table of Contents
