Setting The Power Save Timer - Canon MP360 User Manual

Setting the Power Save Timer

Power Save mode is the mode in which the scanning lamp is extinguished. You can specify the
length of time until the machine enters the Power Save mode by using the Power Save Timer
setting. If you perform an operation immediately after recovering from Power Save mode, the
image may not be correctly read by the machine. If you use the machine frequently, we recommend
that you set the Power Save Timer to <4 HOURS> or <8 HOURS>.
IMPORTANT
• After recovering from Power Save mode, wait at least one minute before scanning or copying.
• The default setting is <1 HOUR>.
Follow this procedure:
1
Press [Additional Functions].
2
Use [ ] or [ ] to select <7.POWER SAVE TIMER>.
USER DATA
7.POWER SAVE TIMER
3
Press [OK/Set].
Ex:
POWER SAVE TIMER
4
Use [ ] or [ ] to select the time to switch the machine to Power Save
mode.
– <1 HOUR>:
– <4 HOURS>:
– <8 HOURS>:
5
Press [OK/Set].
Chapter 10
1 HOUR
Switches the machine to Power Save mode if any key on the operation panel
is not pressed for one hour.
Switches the machine to Power Save mode if any key on the operation panel
is not pressed for four hours.
Switches the machine to Power Save mode if any key on the operation panel
is not pressed for eight hours.
Maintenance
111