READ THIS SHEET FIRST
READ THIS SHEET FIRST
Thank you for purchasing the Canon MultiPASS MP390. To prepare your machine for
use, please follow the instructions in this Set-Up Sheet before referring to any other
documentation.
IMPORTANT
Setup flow
This side explains the setup procedure for use without connecting to a computer. <Check packed contents, install and adjust machine>
Setup procedures
Start
You can use the copy, photo print, fax functions.
These steps explain the setup procedure for use by connecting to a computer. <Install MP Drivers and Utility Software>
Setup procedures
You can use the print, PC fax, scan functions.
Unpack and install the machine.
1
Carefully remove all items from the box.
NOTE
When removing the machine from the
box, handle it with care and do not drop it.
3
Place the machine on a flat surface.
• Be sure to hold the machine by the
sides. Do not place anything in front
of the machine.
Set-Up Sheet
Set-Up Sheet
Do not connect the USB cable until
cable."
Unpack and install
Connect
the machine
telephone line
Install MP Drivers
Hold the bottom side.
Connect
Install print head
Install ink tanks
power cord
Connect USB cable
2
Remove the protective material.
NOTE
After removing the protective material, do
not lift the machine by grasping the scan
unit.
4
Remove all shipping tape from the
exterior of the machine.
Remove the
protective sheet.
• After removing the tape, remove the
protective sheet.
HT3-2145-000-V.1.0
, "Connect the USB
Load print media
Align print head
End
Install Utility Software
Do not grasp the
scan unit.