Nikon ECLIPSE Ti2-U Instruction Manual page 175

Module for DIC microscopy/IMSI
microscopy
Modules for DIC microscopy and IMSI
microscopy have a positioning pin.
Align the pin on the reverse side of the module
with the notch of the turret, and insert the
module into the module. Insert a hexagonal
screwdriver into a hole on the left side of the
condenser turret, and tighten the clamp screw.
ND filter for BF microscopy (module)
When performing BF microscopy, mount the ND
filter for BF microscopy. ND filter for BF
microscopy can be mounted on both 37
mm-dia. position and 39 mm-dia. position by
reversing the ND filter.
To mount the ND filter on the 37 mm-dia.
position, push away the protrusion at the mount
position and insert the ND filter. The tilted filter
is not easily inserted. Be sure not tilt the filter
and push it all the way into the turret. After
inserting the filter, lightly tighten the centering
screws.
After inserting the ND filter on the 39 mm-dia.
position, insert a hexagonal screwdriver into a
hole on the left side of the condenser turret and
tighten the clamp screw.
3. Affix the label of the mounted module to the
condenser turret.
In the position for the BF microscopy module,
affix an [ND] or a [O] label, or an appropriately
named label.
Turn the turret until the position at which the
module is mounted aligns with the opening on
the right or left side, and then affix a label to the
turret.
4. Firmly attach the lid to the upper part of the
condenser module by tightening the two lid
fixing screws using a hexagonal screwdriv-
er.
5. Screw in the condenser lens to the bottom
of the turret.
Attaching a CLWD condenser lens
To mount the CLWD condenser lens, first attach
the TI2-C-CLWDA CLWD condenser adapter to
the bottom of the turret, and then screw in the
CLWD condenser lens.
Condenser centering screws
155
Chapter 7 Assembly of the Devices
Module clamp screw
Label
Lid fixing screws (x 2)
Condenser lens