Associating The Remote Control And The Base Unit - Toro Pro Force Debris Operator's Manual

Figure 35
1. Nozzle guides
Associating the Remote
Control and the Base Unit
Important:
Read the entire procedure before you
attempt the association process.
The remote control must establish communications
with the base unit before you can use the system.
The remote control is associated to the system base
unit before leaving the factory. This is done using
the associate procedure. In situations where it is
necessary to re-establish remote control-to-base unit
communications (example: introducing a new or spare
remote control to an existing base unit or changing
the signal frequency due to local interference issues),
do the following steps.
Only a Pro Force remote control can be associated to
a Pro Force base unit. Associating a Pro Force remote
control to a different Pro Force base unit disassociates
that remote control from the original base unit.
Note:
Local interference may disassociate the
wireless remote from the base unit during operation.
Since the base unit selects the best of numerous
signal frequencies during the association process,
move the machine to the area of signal disruption or
disassociation and perform the association procedure
for best results.
1. Remove power from the base unit.
2. Stand near the base unit in unobstructed, clear
line-of-sight with the remote control in hand.
3. Simultaneously press and hold the R
R and R
IGHT OTATE
blink about once per second.
4. Continue to hold both buttons until the LED
begins blinking about twice per second.
OTATE
L buttons. The LED will
EFT
5. Release the buttons.
6. Press and hold the R
LED will blink about twice per second.
7. Continue holding the R
turn the key start to the R
turns solid if the procedure is successful.
Note:
This could take up to 20 seconds.
8. Release the R
The system is ready for use with that particular
remote control.
g017855
1. LED light
2. Rotate left
3. Decrease engine speed
4. Engine start
30
L button. The
OTATE EFT
L button and
OTATE EFT
position. The LED
UN
L button.
OTATE EFT
Figure 36
5. Rotate right
6. Increase engine speed
7. Engine stop
g029818