Checking The Tire Pressure; Checking The Torque Of The Wheel Lug Nuts; During Operation; During Operation Safety - Toro Pro Force Debris Operator's Manual

Checking the Tire Pressure

Check the tire pressure
The correct tire pressure is 96.5 kPa (14 psi).
Checking the Torque of the
Wheel Lug Nuts
Service Interval: After the first 10 hours
Check the torque of the wheel lug nuts initially and
after the first 10 hours of operation.
WARNING
Failure to maintain proper torque could result
in failure or loss of wheel and could result in
personal injury.
Torque wheel lug nuts to 95 to 122 N⋅ ⋅ ⋅ m (70
to 90 ft-lb).
(Figure 11).
Figure 11

During Operation

During Operation Safety

General Safety
•
The owner/operator can prevent and is responsible
for accidents that may cause personal injury or
property damage.
•
Wear appropriate clothing, including eye
protection; long pants; substantial, slip-resistant
footwear; and hearing protection. Tie back long
hair and do not wear loose jewelry.
•
Do not operate the machine while ill, tired, or
under the influence of alcohol or drugs.
•
Use your full attention while operating the
g001055
machine. Do not engage in any activity that
causes distractions; otherwise, injury or property
damage may occur.
•
Discharged air has considerable force and could
cause injury or loss of footing. Stay away from the
blower nozzle when the machine is operating.
•
Keep all bystanders away; shut off the machine
when bystanders enter the area, do not direct
discharge toward them.
•
Do not operate the machine when it is not
connected to a towing vehicle.
•
Do not run the engine in or direct the blower nozzle
into a confined area without adequate ventilation.
Engine exhaust contains carbon monoxide, an
odorless gas that is fatal if inhaled.
•
Do not carry passengers on the machine and
keep bystanders and pets away from the machine
during operation.
•
Operate the machine only in good visibility to avoid
holes or hidden hazards.
•
Look behind and down before backing up to be
sure of a clear path.
•
Use care when approaching blind corners, shrubs,
trees, or other objects that may obscure your
vision.
•
Never run an engine in an area where exhaust
gasses are enclosed.
•
Never leave a running machine unattended.
•
When transporting the machine on public roads,
follow all traffic regulations and use any additional
accessories that may be required by law, such as
lights, turn signals, slow-moving vehicle (SMV)
signs, and others as required.
•
If the machine ever vibrates abnormally, stop the
machine immediately, shut off the engine, remove
the key, wait for all moving parts to stop, and
inspect for damage. Repair all damage to the
machine before resuming operation.
13