Associate Remote Control And Base Unit; Servicing The Spark Plugs - Toro Pro Force 44553 Operator's Manual

3. Apply a thin coat of new oil to the rubber gasket on
the replacement filter
4. Install the replacement oil filter to the filter adapter,
turn the oil filter clockwise until the rubber gasket
contacts the filter adapter, then tighten the filter an
additional 2/3 to 1 turn
5. Fill the crankcase with the proper type of new oil; refer
to Servicing the Engine Oil (page
6. Run the engine for about 3 minutes, stop the engine,
and check for oil leaks around the oil filter.
7. Check the engine oil level and add oil if needed.
Associate Remote Control and
Base Unit
Important: Make sure to read the entire procedure
before attempting the association process.
The remote control must establish communications with
the base unit before the system can be used. The remote
control is associated to the system base unit before leaving
the factory. This is done using the associate procedure.
In situations where it is necessary to re-establish remote
control-to-base unit communications (example: introducing
a new or spare remote control to an existing base unit), the
following associate procedure must be performed.
Note: Associating the remote control to a different base
unit will disassociate that remote control from the original
base unit.
1. Remove power from the base unit.
2. Stand near the base unit in unobstructed, clear
line-of-sight with the remote control in hand.
3. Simultaneously press and hold the R
and R L
OTATE EFT
once per second.
4. Continue to hold both buttons until the LED begins
blinking about twice per second.
5. Release the buttons.
6. Press and hold the R
will blink about twice per second.
7. Continue holding the R
the key start to the R
solid if the procedure is successful.
Note: This could take up to 20 seconds.
8. Release the R
OTATE
The system is ready for use with that particular remote
control.
(Figure 25).
(Figure 25).
21).
R
OTATE
buttons. The LED will blink about
L button. The LED
OTATE EFT
L button and turn
OTATE EFT
position. The LED will turn
UN
L button.
EFT
1. LED light
2. Rotate left
3. Decrease engine speed
4. Engine start

Servicing the Spark Plugs

Ensure that the air gap between the center and side electrodes
is correct before installing the spark plugs. Use a spark plug
wrench for removing and installing the spark plugs and a
gapping tool/feeler gauge to check and adjust the air gap.
Install new sparks plugs if necessary.
Type: Champion® RC12YC, Champion® Platinum 3071 or
equivalent
Air Gap: 0.76 mm (0.030 inch)
Checking the Spark Plugs
Service Interval: Every 200 hours
IGHT
1. Look at the center of the spark plugs
you see light brown or gray on the insulator, the engine
is operating properly. A black coating on the insulator
usually means that the air cleaner is dirty.
1. Center electrode insulator
2. Side electrode
23
Figure 26
5. Rotate right
6. Increase engine speed
7. Engine stop
(Figure
Figure 27
3. Air gap (not to scale)
27). If