Associate Remote Control And Base Unit - Toro 44539 Operator's Manual

1. Oil filter
2. Adapter gasket
3. Apply a thin coat of new oil to the rubber gasket on
the replacement filter (Figure 26).
4. Install the replacement oil filter to the filter adapter,
turn the oil filter clockwise until the rubber gasket
contacts the filter adapter, then tighten the filter an
additional 2/3 to 1 turn (Figure 26).
5. Fill the crankcase with the proper type of new oil;
refer to Servicing the Engine Oil.
6. Run the engine for about 3 minutes, stop the engine,
and check for oil leaks around the oil filter.
7. Check the engine oil level and add oil if needed.
Associate Remote Control and
Base Unit
Important: Make sure to read the entire procedure
before attempting the Association process.
The remote control must establish communications with
the base unit before the system can be used. The remote
control is associated to the system base unit before
leaving the factory. This is done using the Associate
procedure. In situations where it is necessary to
re-establish remote control-to-base unit communications
(example: introducing a new or spare remote control to
an existing base unit), the following Associate procedure
must be performed.
Note: Associating the remote control to a different
base unit will disassociate that remote control from the
original base unit.
1. Remove power from the base unit.
2. Stand near the base unit in unobstructed, clear
line-of-sight with the remote control in hand.
3. Simultaneously press and hold the Associate and
Disassociate buttons. TX lights steady Green.
4. Continue to hold both buttons until the LINK LED
begins flashing Amber.
Figure 26
3. Adapter
Note: If the flashing LINK LED goes solid, the
Association procedure is aborted and must be started
anew to establish the communication link.
5. When the LINK LED flashes Amber, release the
two buttons. All three LEDs flash allowing two (2)
seconds for the operator to perform the next step.
Note: If the next button press is not performed
within the two second, the Association procedure is
aborted and must be started anew to establish the
communication link.
6. Press and hold the Associate button. The RX LED
goes out, the TX LED lights steady green, and the
LINK LED lights steady amber.
7. Apply power to the base unit while continuing to
hold the Associate button.
The remote control and base unit begin to establish
a communication link while the Associate button
is held. Once the process is complete, the Amber
LINK LED remains solid, the RX LED stops
flashing Red and the TX LED lights steady Green
(button being held) until the button is released, upon
which time TX begins flashing Green indicating that
the remote control is transmitting.
8. Release the Associate button.
RX extinguishes and TX flashes Green for a brief
time and then it too goes out.
The system is ready for use with that particular
remote control.
3
4
5
1. Associate
2. Disassociate
3. TX
24
g017704
Figure 27
4. RX
5. LINK