Setup; Connecting The Battery - Toro Pro Force Debris Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
Media and Additional Parts
Description
Operator's Manual
Engine owner's manual
Remote control
Declaration of Conformity
Note:
Determine the left and right sides of the
machine from the normal operating position.
1

Connecting the Battery

Parts needed for this procedure:
—
Grafo 112X grease (Toro Part No. 505-47)
Procedure
1. Remove the clips securing the battery cover to
the battery box (Figure
Description
Grafo 112X grease (Toro Part No.
505-47)
Debris blower assembly
Hitch
Bolt (3/8 x 3 inches)
Flange nut (3/8 inch)
Hitch clevis
Bolt (5/8 x 4–1/2 inch)
Locknut (5/8 inch)
Hitch pin
Clevis
Handheld remote
AAA batteries
Screws (small)
3).
Qty.
—
1
1
2
2
1
2
2
1
1
1
4
6
Qty.
1 Read before operating.
1 Use to reference the engine operation and maintenance.
1 Use to remotely operate the blower.
1 For CE compliance.
1. Battery cover
7
Use
Connect the battery.
Mount the hitch to the debris blower.
Connect the blower to the tow vehicle.
Assemble the handheld remote.
Use
Figure 3
2. Battery clip
g029816