Product Overview; Controls - Toro Pro Force Debris Operator's Manual

Product Overview

Controls

Engine Stop
Press the Engine Stop button to shut off the engine
(Figure 7).
1. LED light
2. Rotate left
3. Decrease engine speed
4. Engine start
Engine Start
After completing the starting sequence, press the
Engine Start button to start the engine
Refer to Starting the Engine (page 15)
sequence.
Blower Nozzle Direction
Press the right or left button to rotate the blower
nozzle to the desired direction
Engine Speed
Press the Increase Engine Speed (rabbit) or Decrease
Engine Speed (turtle) button to increase or decrease
the speed of the engine
Increase Engine Speed and Decrease Engine Speed
buttons at the same time returns the engine to idle.
Ignition Switch
The ignition switch (Figure
and shut off the engine, has three positions: O
R and S . Rotate the key clockwise to S
UN TART
to engage the starter motor. Release the key when
the engine starts. The key moves automatically to the
R position. To shut the engine off, rotate the key
UN
counterclockwise to the O
Figure 7
5. Rotate right
6. Increase engine speed
7. Engine stop
(Figure
for the starting
(Figure 7).
(Figure 7). Pressing the
8), which is used to start
position.
FF
Choke Control
To start a cold engine, move the choke control lever
(Figure 8) to the O
1. Choke control
g029818
2. Hour meter
Hour Meter
The hour meter
machine operation.
Diagnostic Light
The diagnostic light
7).
hour meter and indicates machine fault codes. After
you turn the key to the R
light illuminates for 5 seconds, turns off for 5 seconds,
and then flashes 3 times a second until you push a
button on the handheld remote. If the light turns on for
5 seconds and then starts blinking 10 times a second
(with or without a 5-second pause) there is a fault with
the machine; refer to
Note:
If you press a button on the handheld remote
when you start the machine, the light does not flash 3
times a second after it turns off for 5 seconds.
,
FF
TART
10
position.
N
Figure 8
3. Ignition switch
(Figure 8) indicates the total hours of
(Figure 9) is located below the
position, the diagnostic
UN
Checking Fault Codes (page
g029819
32).