Servicing The Spark Plugs - Toro Pro Force Debris Operator's Manual

1. Oil filter
2. Adapter gasket
3. Apply a thin coat of new oil to the rubber gasket
on the replacement filter
4. Install the replacement oil filter to the filter
adapter, turn the oil filter clockwise until the
rubber gasket contacts the filter adapter, then
tighten the filter an additional 2/3 to 1 turn
(Figure 23).
5. Fill the crankcase with the proper type of new
oil; refer to Changing the Oil (page
6. Run the engine for about 3 minutes, shut off the
engine, and check for oil leaks around the oil
filter.
7. Check the engine oil level and add oil if needed.

Servicing the Spark Plugs

Ensure that the air gap between the center and side
electrodes is correct before installing the spark plugs.
Use a spark plug wrench for removing and installing
the spark plugs and a gapping tool/feeler gauge to
check and adjust the air gap. Install new sparks plugs
if necessary.
Type: Champion® RC12YC, Champion® Platinum
3071 or equivalent
Air Gap: 0.76 mm (0.030 inch)
Figure 23
3. Adapter
(Figure 23).
23).
g001056
24