Husqvarna Rider PR 17 Workshop Manual page 58

5. Release the hydraulic pipe from the top
of the rear axle. Fit the protective plugs.
A small amount of oil will leak out even if
the rear axle has not been drained.
6. Remove the 4 screws which hold the
rear axle and lower the rear axle.
Assembly
1. Assemble the rear axle in the reverse
order in relation to dismantling. The
bearing on the right-hand side is turned
so the grease nipple points backwards.
Tighten the right-hand side bearing
before the left side bearing.
2. The stop screws for the bearing on right-
hand side are tightened after the five
screws holding the rear axle have been
tightened.
3. Grease the axles for protection against
corrosion before the wheels are fitted.
4. Fill with oil and vent the entire hydraulic
system according to "Bleeding the
Hydrostatic and Hydraulic Systems PR
17 AWD, PF 21 AWD" on page 66.
5. Check and adjust the speed coordination
between the front wheels and rear
wheels according to the separate
instruction.
56
English-
REPAIR INSTRUCTIONS
Hydraulic pipe top
Mounting bolts left side
Mounting bolts right side