Husqvarna Rider PR 17 Workshop Manual page 116

Control Valve, Dismantling/Assembly
1. Remove the control valve, see above.
2. Clean in accordance with "Working
Methods" on page 106.
3. Place the valve in the vice. Tighten down
on the lower part (under the slider hole).
4. Remove the check valve. Set the tool to
the wide wrench setting, 15 mm.
5. Remove lever housing and lever. By
lifting the lever housing and twisting the
lever backwards, it can be unhooked
from the hole in the slider.
6. Remove the plastic plug and unscrew
the spring holder with a 12 mm Allen key.
114
English-
HYDRAULIC SYSTEM
Lever housing with lever
Spring holder
Check valve