Husqvarna Rider PR 17 Workshop Manual page 38

8. Loosen the cover plate over the muffler,
two screws on each side of the muffler,
and remove the plate.
Remove the radiation guard under the
muffler (only AWD).
9. Loosen the exhaust pipe's pipe clamp
and the muffler's four fastening screws.
Then remove the muffler and the
exhaust pipe.
10. Remove the belt guide for the engine
belt pulley. On machines with a skid
guard the skid guard must be removed.
11. Push tool no. 506 56 76-01 into the
centre of the engine belt pulley. Loosen
and remove the Allen screw that holds
the belt pulley and engine shaft together.
Use tool no. 506 89 92-01 to counter.
Loosen the belt pulley from the engine
shaft.
36
English-
REPAIR INSTRUCTIONS
Muffler cover plate
Exhaust system
Belt guide
Engine belt pulley
506 56 76-01