Husqvarna Rider PR 17 Workshop Manual page 56

11. Loosen the stop screws (2) and remove
the bearing on right-hand side.
Assembly
1. Assemble the front axle in the reverse
order in relation to dismantling. Tighten
the left side bearing before the right
bearing.
2. The stop screws for the bearing on right-
hand side are tightened after the five
screws holding the front axle have been
tightened.
3. The synchronisation link is fitted in the
upper hole on PR 17 AWD and in the
lower hole on PF 21 AWD.
(Below the holes for the synchronisation
link is a hole for the release control)
4. Grease the axles for protection against
corrosion before the wheels are fitted.
5. Fill with oil and vent the entire hydraulic
system according to "Bleeding the
Hydrostatic and Hydraulic Systems PR
17 AWD, PF 21 AWD" on page 66.
6. Check and adjust the parking brake
cable.
7. Check and adjust the speed coordination
between the front wheels and rear
wheels according to the separate
instruction.
54
English-
REPAIR INSTRUCTIONS
Rear front axle mounting
Right front axle bearings
Synchronisation link