Shower Fittings - Rear Fed - Mira Vision Owner's Installation Manual

Place first washer in end of hose,
then attach to pipe end. Do not fit
showerhead until after pipework has
been fully flushed through. See section
"Commissioning".

Shower Fittings - Rear Fed

Suitable for solid, dry-lined, stud partition, shower cubicle or laminated panel walls.
The Slide Bar should be fixed to the wall at a convenient height for all the family.
It should be positioned so that water sprays down the centre of the bath, or away
from the opening of a shower cubicle. Water should spray away from the Wireless
Controller when the Showerhead is held on the Slide Bar.
Decide on suitable position for Slide
Bar avoiding buried cables and pipes
in wall.
Using template as guide, mark
positions of the fixing holes for Wall
Brackets (600 mm).
Note! Use spirit level to make sure
fixing holes are vertical.
Drill and plug fixing holes.
1184347-W2-G
m
0 m
6 0
26