Solid Wall Or Stud Partition (Using Rear Fixing Points On Shower Control) - Mira DISCOVERY Installation And User Manual

2. Solid Wall or Stud Partition
(Using Rear Fixing Points on Shower Control)
2.1 Refer to section: '1. Solid Wall or
Stud Partition (Using Securing
Brackets - Mounting off Front
Face)' and follow steps 1.1 to 1.4.
2.2 Cut away the plasterboard or brick
work to the required depth.
Important! This depth 'X' will depend
on the finished wall thickness e.g. tiles
or facia board. Refer to the table for
this measurement.
For stud partitions depth 'X' refers to
the distance from the rear mounting
e.g. timber noggin, to the front of the
wall (before tiling).
Finished Wall Thickness
(e.g. tile and adhesive)
Important! Total building-in depth ( X + Finished Wall Thickness) must not exceed
an absolute maximum of 85mm.
Rear Support
4 mm
6 mm
8 mm
10 mm
12 mm
14 mm
16 mm
18 mm
20 mm
22 mm
24 mm
22
Depth 'X'
Wall Cutout Depth 'X'
81 - 63 mm
79 - 61 mm
77 - 59 mm
75 - 57 mm
73 - 55 mm
71 - 55 mm
69 - 55 mm
67 - 55 mm
65 - 55 mm
63 - 55 mm
61 - 55 mm
Finished Wall
Surface
Finished Wall
Thickness