Mira Vision Owner's Installation Manual page 33

Run cold water through (approximately
2 minutes) and check entire installation
for water leaks. Press " " to turn shower
off. Fit the second hose washer and
showerhead.
Press " " to turn shower on. Test operation
of shower by increasing/decreasing both
temperature and flow controls. (See User
Guide for full details.)
Test operation of showerhead spray
modes. (See Showerhead User Guide for
full details.)
Refer to User Guide for further instructions
on how to use the shower.
The Wireless Controller factory default settings are as follows:
Maximum Showering Temperature = 45°C
Eco Mode
Warm-Up Mode
Clock
Clock Display
Run the shower and adjust the maximum shower temperature to suit user
requirement.
Eco, warm-up and clock display can also be altered to suit, refer to wireless
controller guide.
= Off
= Off
= 10:00 (when batteries connected)
= On
33
1184347-W2-G