Faxing Problems; Error Codes; Error Messages - Toshiba e-Studio2000AC Software Troubleshooting Manual

Faxing Problems

0.
 Error codes
To learn the meanings of the error codes described in the lists or reports, see the following section:
 P.64 "Error codes on transmission and reception"
 Error messages
Below is a list of error messages that might appear on the touch panel. When any message in the list appears on the
touch panel, press [FUNCTION CLEAR] on the control panel to clear it, and then take action suggested in the
"Remedy" column.
Message
Memory overflow
Communication error
Job reservation full
Job memory full
Sorry not possible
Not allowed now
Too Many Tel # Digits
Fax line1 is out of
order./Fax line2 is out
of order.
Never attempt to repair, disassemble or modify the equipment by yourself.
You could cause a fire or get an electric shock. Always contact your service representative for maintenance or repair of
the internal parts of the equipment.
54 Faxing Problems
Cause
Memory overflowed when scanning
documents to the memory.
Communication error occurred during
direct TX.
The number of reserved jobs exceeded the
maximum.
The total number of destinations for
reserved jobs exceeded the maximum.
On-hook or direct TX was attempted
during communications.
Further polling transmission reservation
was attempted even though polling
transmission was already reserved.
128 digits or more were registered for a
chain dial communication.
An error occurred with the Fax unit.
Remedy
Either wait for memory to be cleared, or check
the jobs and delete reserved jobs on the [Job
Status] screen.
Retry communications.
Either wait for job reservations to be
completed, or check the jobs and delete
reserved jobs on the [Job Status] screen.
Either wait for job reservations to be
completed, or check the jobs and delete
reserved jobs on the [Job Status] screen.
Wait for communications to end and retry
communications.
Either wait for polling transmission jobs to be
completed, or check the jobs and delete
reserved jobs on the [Job Status] screen.
Confirm the number of digits dialed and
register the numbers again.
Turn the power OFF and then back ON. If the
error still persists, contact your service
representative.