Using Sticky Media - Roland VersaArt RE-640 User Manual

Using Sticky Media

Procedure

Press .

MENU
SUB MENU

SUB MENU
MEDIA RELEASE

MEDIA RELEASE
DISABLE ENABLE

W1200mm
SETUP SHEET
Description
Some types of media may tend to stick to the platen. Starting printing with the media sticking to the platen
may make normal media feed impossible and cause the media to jam. When you're using such media, set the
[MEDIA RELEASE] menu item to "ENABLE." This peels off the media if sticking before starting printing.
Note, however, that media feed may be unstable when printing is performed after executing this operation.
Leave this menu item set to "DISABLE" unless you specifically need to change it.
Default Setting
[MEDIA RELEASE]: DISABLE
Accommodating to the Types and Condition of Media
Press several times to display the left figure.
Press .
Press several times to display the left figure.
Press .
Press
Press to enable the setting.
Press to go back to the original screen.
to select "ENABLE."
4
101