Controlling The Media Heating System During Preheating - Roland Soljet EJ-640 User Manual

Examples of Temperature Settings
Media
Type: Scrim banner (PVC)
Thickness: 300 to 400 μm (12 to 16 mil)
Type: Marking film (PVC, with adhesive)
Thickness: 60 to 100 μm (2.5 to 4 mil; not includ-
ing backing paper)
 These are only rough estimates. Make adjustments to match the media you're using.
 Using the media heating system does not necessarily make it possible to apply ink to every kind of media.
Be sure to test in advance.
 Results may vary greatly depending on the print mode and other factors. Make settings suited to the media.
 When suggested settings for temperature, print mode, and other values are given, use the suggested settings.
Description
With the default settings, simply switching on the power does not make the media heating system warm up
to the set temperature. The temperature rises to the set temperature when the media is loaded correctly and
lights. You can also make this setting in the software RIP. When you have made the setting in the
software RIP, the software RIP's setting is used.
Note: Depending on the usage environment, the temperature of the print heater or dryer may become higher
than the set temperature, but this does not represent a problem.
Default Settings
[PRE]: 40°C (104°F)
[PRINT]: 40°C (104°F)
[DRY]: 50°C (122°F)

Controlling the Media Heating System during Preheating

Note: Preheating: State in which the main power and the sub power are switched on and
(state in which the media setup is not completed)
Procedure

Hold down

HEATER MENU
PREHEATING
and press .
Press
on the left.
Press
Fully Utilizing the Media Heating System
Temperature
Preheater: 40°C (104°F)
Print heater: 40°C (104°F)
Dryer: 50°C (122°F)
, then to display the screen shown
.
4
is not lit
87