Getting Ready To Receive Data From A Computer - Roland VersaArt RE-640 User Manual

How to Perform a Normal cleaning
Procedure

Press .

FUNCTION
CLEANING

CLEANING
NORMAL
CLEANING...
>>
CLEANING
NORMAL

W1200mm
SETUP SHEET

Perform a printing test again to make sure the dot drop-out has been corrected.
If the problem persists, try performing cleaning a second time. If the printer has been used for a long
period, the problem may persist even after two or three-cycle cleaning. Then try cleaning using a differ-
ent method.
 P. 64, "When Normal Cleaning Is Not Effective"

Getting Ready to Receive Data from a Computer

When p. 33, "Loading Media," p. 43, "Setup of Media" are completed, get ready to receive the data from a
computer.
CAUTION
Procedure

Close the front cover.

Make sure
If the light does not come on, lower the loading lever.

Wait until
When "OFF" is set to the print heater and the dryer,
 P.87, "Making the Temperature Setting for the Media Heating System"
Press , and then
Press .
Normal cleaning starts.
When it finishes, the screen shown in the figure appears again.
Press
Never touch the print heads while output is in progress.
The print heads move at high speed. Contact may cause injury.
stays steadily lit.
stays steadily lit.
.
to go back to the original screen.
lamp stays dark. Go to procedure
Outputting
2

.
51