Table of Contents
Advertisement
RESTRICTED USE ONLY
Resolving the Blank Output issues (continued)
Step
Procedure
6
Ensure that the proper voltage is being applied to the Printhead.
a. Remove the back cover.
b. Using a Digital Voltmeter, connect the negative lead to ground.
c. Probe Pins 1 to 5 of the Printhead power connection on J16.
d. Ensure that a voltage between 22 to 23 VDC is read on each pin.
•
If less than 22 volts is read on any of the pins, replace the Printhead.
•
If still having issue with blank cards, replace the Main Board.
Persona M30e Card Printer User Guide (Rev. 1.1)
Fargo Electronics, Inc.
4-33
Advertisement
Table of Contents
