Table of Contents
Advertisement
RESTRICTED USE ONLY
Resolving a Card Not Fed Error (Cards will not feed off the Hopper) (continued)
Step
Procedure
7
Card Hopper Feed Roller is not turning during a print job.
a. Remove the Printer rear cover.
b. Ensure that the Card Hopper Feed Motor power cable is securely connected
to J-20 on the Printers Main Board.
c. Ensure that the Card Hopper Feed Motor power cable is securely connected
to the Card Hopper Feed Motor.
d. Use the Fargo Workbench Printer Utility to send a test print to the Printer.
e. If the Card Hopper Feed Motor is not moving, continue to Step 8.
8
Replace Card Hopper Feed Motor.
a. Replace the Card Hopper Feed Motor.
b. Use the Fargo Workbench Printer Utility to send a test print to the Printer.
c. If the Card Hopper Feed Motor does not turn, replace the Main Board.
Persona M30e Card Printer User Guide (Rev. 1.1)
Fargo Electronics, Inc.
4-6
Advertisement
Table of Contents
