RESTRICTED USE ONLY
Resolving a No Ribbon Installed Error (continued)
Step
Procedure
2
Verify that a Ribbon Cartridge is installed in the Printer.
a. Press on the Resume button.
b. If the issue persists, continue to Step 3.
3
Remove the rear cover and check that the Ribbon RFID cable is securely
connected to the Main Board (J-5) and the RFID Sensor.
•
If the connections are loose, reattach them.
•
Press on the Resume button.
•
If the connections are good or if the issue persists, continue to Step 4.
4
Replace the Ribbon RFID Sensor.
Persona M30e Card Printer User Guide (Rev. 1.1)
Fargo Electronics, Inc.
4-21