Vision Fitness Vision Series Service Manual page 14

Engineering mode (T9200/T9250)
1. Check the model and unit switch on the back side of Upper control board
SW KM
T9250 S1:ON
S4:ON
T9200 S1:OFF S1:OFF
S4:ON
2. Put on the safety key.Press UP+ SLOW Keys for five seconds at the same time until it
displays "ENG1" .
3. Press START and then it displays P0 ( Minimum Speed)
4. Press START. Press SELECT/SCAN to display Min speed. Press Elevation
UP/DOWN or Speed FAST/SLOW to increase/decrease speed to 0.5m/1.0 km. Press
START to store. Then Press Exit. .
5. Press Elevation UP or Speed UP Key until it displays P1(Maximum Speed)
6. Press START. Press SELECT/SCAN to display Max speed. Press Elevation
UP/DOWN or Speed FAST/SLOW to increase/decrease speed to 10m/16 km. Press
START to store. Then Press Exit.
7. Press Elevation UP or Speed UP Key until it displays P5(Maximum incline)
8. Press Start and let it rise to Max incline automatically. Press START to store.
9. Press Elevation DOWN or Speed DOWN Key until it displays P4(Minimum incline)
10. Press Start and let it down to Min incline. Press START to store. Remove the safety
and install it again, Finish setup
P0: Minimum Speed
P1: Maximum Speed
P4: Minimum incline
P5:Maximum incline
Press Start to Save
Hold Down+Fast key for five second to clear P9/P10
*
MILE
S1:ON
S4:OFF
S4:OFF
P7:Maximum Program time
P8:Weight
P9:Accumlated time
P10: Accumulated distance
Press Stop to Exit
3-1