Vision Fitness Vision Series Service Manual page 45

INCLINE MOTOR REPLACEMENT
Tools required:
Philips screwdriver
Wrench (14mm)
Wrench ( 17mm)
nut and a bolt on the pipe by using the wrenches (14, 17).
7. Remove the support under the frame.
8. Turn on the power and enter the Engineering Mode to check if the extreme
inclines are within the correct range.
9.
Install motor covers and secure the screws.
Procedure:
1. Remove screws of both top and bottom
motor covers by using a screwdriver
2. Disconnect cables from the connectors
of the incline motor and MCB and also
disconnect the ground wire.
3. Fold up the treadmill and then loose a
4. Replace the incline motor with a new
one.
PS. Let the incline motor in max incline
status.
5. Tighten a nut and a bolt on the incline
motor at first. Then lift the main frame in
max incline status and tighten the pipe.
6. Reconnect cables and the grounding
wire to the connectors and the frame.
7-8
(T9250/9350/9450HRT)