Vision Fitness Vision Series Service Manual page 31

Error Message " E1" or "E2"
Possible cause:
1. EEPROM error.
2. PCB is damaged.
Fix:
1.Re-calibrate the parameters from P0 to P6 then check again
.
2. Replace PCB.
For T9250
1. Re-calibrate the parameters P4 and P5
2 If the elevation is stuck at either end, release the pipe before the calibration
Error Message " E3" on the Console
Possible cause:
1. Speed is out of range.
2. PCB is damaged.
Fix:
1. Enter the engineering mode to re-calibrate the speed.
2. Replace PCB.
7-8 Revision: 1.0 Date: 2000-04-01