Installing The Summit Xgm2-2Xf Option Card - Extreme Networks Summit X450a-24tDC Hardware Installation Manual

Summit X450a-24xDC switch, running ExtremeXOS 11.6.1 (or later)
●
Summit X450a-48t switch, running ExtremeXOS 11.5.0 (or later)
●
Summit X450e-24p switch, running ExtremeXOS 11.5.0 (or later)
●
Summit X450e-48p switch, running ExtremeXOS 11.6.1 (or later)
●
The Summit XGM2-2xf option card is compatible with the following 10-gigabit XFP modules:
LR XFP module
●
SR XFP module
●
Figure 87 shows the Summit XGM2-2xf option card.
Figure 87: Summit XGM2-2xf Option Card
NOTE
Refer to the Extreme Networks Pluggable Interface Modules Installation Guide for more information about XFP
modules.

Installing the Summit XGM2-2xf Option Card

CAUTION
The Summit XGM2-2xf option card is not hot-swappable. Disconnect power to the switch before installing or
removing the Summit XGM2-2xf option card. After the Summit XGM2-2xf option card is installed in a compatible
switch, XFP modules may be hot-swapped into and out of the option card. Use only XFP modules approved by
Extreme Networks.
CAUTION
Be sure that the option slot always has either an installed Summit option card or a faceplate over the opening. An
open slot could divert air from the switch and cause overheating.
Summit Family Switches Hardware Installation Guide
SH_011
Summit XGM2-2xf Option Card
123