Remote Logging; Logging Commands - Extreme Networks BlackDiamond 6800 User Manual

S M S
TATUS ONITORING AND TATISTICS
R L
EMOTE OGGING
In addition to maintaining an internal log, the BlackDiamond supports remote logging
by way of the UNIX syslog host facility. To enable remote logging, do the following:
• Configure the syslog host to accept and log messages.
• Enable remote logging by using the following command:
enable syslog
• Configure remote logging by using the following command:
config syslog <ipaddress> <facility> {<priority>} {<subsystem>}
Specify the following:
• — The IP address of the syslog host.
ipaddress
• — The syslog facility level for local use. Options include
facility
.
local7
• — Filters the log to display message with the selected priority or higher
priority
(more critical). Priorities include critical, warning, and informational. If not specified,
only critical priority messages are sent to the syslog host.
• — Filters the log to display messages associated with the selected
subsystem
subsystem. Subsystems include Syst, STP Brdg, SNMP, Telnet, VLAN, and Port. If
not specified, all subsystems are sent to the syslog host.
Refer to your UNIX documentation for more information about the syslog host
facility.
L C
OGGING OMMANDS
The commands described in
logging options, display the log, and clear the log.
11-14
Table 11-5 allow you to configure logging options, reset
through
local0
B D U
LACK IAMOND
G
SER UIDE