Extreme Networks BlackDiamond 6800 User Manual page 146

R P
OUTING ROTOCOLS
Table 9-4: OSPF Configuration Commands (continued)
Command
config ospf area delete range <ipaddress>
<mask>
config ospf routerid [automatic | <routerid>]
config ospf [vlan <name> | area <areaid> |
virtual-link <routerid>] timer
<retransmission_interval>
<transmission_delay> <hello_interval>
<dead_interval>
config ospf spf-hold-time {<seconds>}
9-16
Description
Deletes a range of IP addresses in an OSPF
area.
Configures the OSPF router ID. If automatic is
specified, the switch uses the largest IP
interface address as the OSPF router ID. The
default setting is automatic.
Configures the timers for one interface or all
interfaces in the same OSPF area. The
following default, minimum, and maximum
values (in seconds) are used:
retransmission_interval
Default: 5
Minimum: 0
Maximum: 3600
transmission_delay
Default: 1
Minimum: 0
Maximum: 3600
hello _interval
Default: 10
Minimum: 1
Maximum: 65535
dead_interval
Default: 40
Minimum: 1
Maximum: 2147483647
Configures the minimum number of seconds
between Shortest Path First (SPF)
recalculations. The default setting is 3 seconds.
B D U G
LACK IAMOND SER UIDE