How To Install The Hob - CDA HVG621 Directions For Installation, Use And Maintenance

Table of Contents

How to Install the Hob

How to install the hob:

Overall hob dimensions:

Worktop cut-out dimensions:

1. Make the required hole in the worktop. Note that before doing this,

check the instructions supplied with any cooker hood to ensure that

you will have the required clearance. The hob cut-out (Fig 6) shows

a minimum 50mm gap from the rear wall or splashback to the cut-

out edge.

2. Position the hob seal, as shown in the diagram below (Fig 8),

ensuring that the ends meet without overlapping. Do not use

silicone type sealant.

3. Secure the hob to the worktop using the ﬁxing brackets and screws

supplied, as shown in the following diagram (Fig 9).

Remove any excess sealant after tightening the brackets.

185mm

150mm

Fig.6

Fig.8

>50mm

477mm

560cm

557mm

185mm

150mm

Fig.9

HVG621 = 595mm (W) x 515mm (D)

HVG721 = 700mm (W) x 515mm (D)

557mm (W) x 477mm (D)

Fig.7

3cm

4cm

Table of Contents

Hvg721