Fitting The Hob - CDA HVG621 Directions For Installation, Use And Maintenance

Fitting the Hob

Unpacking the hob:
Take care not to lose or mishandle any
parts.
15mm
Ventilation slot > 30mm
Fig.5
Fitting position of the hob:
This appliance must be installed in accordance with the dimensions
given in Fig.6 on page 17 of this manual and a minimum of 150mm
away from any adjacent vertical surfaces, e.g. a tall cupboard end
panel. This may be reduced to 100mm if the adjacent surface is
resistant to fire (tiles or steel, for example). These dimensions are
shown in Fig.6.
If fitting a cooker hood above the hob:
If a cooker hood is to be installed above the hob, the height of
the hood above the hob must be at least 700mm (750mm is
recommended) (Fig.7).
If the instructions supplied with the hood dictate that the hood must
be installed at a height greater than 700mm, then that height is the
minimum required.
Wall furniture requirements:
The minimum height of any cabinet immediately above the hob is
900mm.
The minimum height of any adjacent units (including light pelmets) is
400mm, unless they are manufactured from a material resistant to fire
(steel, for example).
15